Once both have been loaded, it will flash the uImage kernel into NAND memory at 0x100000. The bootloader will attempt to load files "uImage" followed by "initrd". Enter USB firmware instllation by RESET IO. At this stage uBoot will have entered the USB firmware installation mode and you can release the reset pin. The yellow light will blink immediately followed by the white LED. Hold the reset pin while power is applied. The hard disk should be removed from the dock, otherwise the hard disk may come up as /dev/sda rather than the USB stick and prevent the *.ubi file being found. The GoFlex Home has a firmware recovery mechanism built into the bootloader.įirmware can be loaded onto a FAT32 formatted USB stick and inserted into the rear USB host port. 4 RAMDisk Size Issues (attempt to access beyond end of device).
0 kommentar(er)
